aguirola
Well-Known Member
Per the title, I am going to start the manufacture of Hyper lightweight front and rear bumpers.
You can see the end result here:
The result has been terrific, and they look great.
I am interested in starting production once I post realistic prices for front and rear,
and people express an interest in them.
This week we will start manufacture on one full set that a fellow E9er has commissioned.
Very kindly, he has volunteered for their build, to figure out time and materials required,
then I will be able to post accurate figures and logistics. We have a ballpark figure,
but as anything, it has to be fine tuned.
If you like, this only an announcement, so please wait until the next post.
Stay tuned...
Regards, Alberto
You can see the end result here:
CSL Bumpers
If anybody would be interested, I am planning to pull a mould off my original and very heavvvy front bumpers and replicate in fibreglass, a few lbs, instead of the 50 lbs. or so. No over riders or rubber trim. Please send a pm, or post your thoughts. Regards, Alberto
e9coupe.com
The result has been terrific, and they look great.
I am interested in starting production once I post realistic prices for front and rear,
and people express an interest in them.
This week we will start manufacture on one full set that a fellow E9er has commissioned.
Very kindly, he has volunteered for their build, to figure out time and materials required,
then I will be able to post accurate figures and logistics. We have a ballpark figure,
but as anything, it has to be fine tuned.
If you like, this only an announcement, so please wait until the next post.
Stay tuned...
Regards, Alberto
Last edited: