Rubber FAQ

@eriknetherlands ,

Turns out I do have those rubber washers for the blinker lenses. Here is a second set of measurements.

F06A53BF-B7F4-4BAA-8F96-CEF1B27AABE8.jpeg
55D089C7-62DB-487B-A4B5-ACFF8C59A1AB.jpeg
F0BF34B3-41FF-43F4-B1B9-38C98BD14637.jpeg
 
Question on rear quarter glass, what seals to the inside of the glass? Same seal as door but cut down? Or different number?
I found the door ones at Maximillian (max2002store.com) as e9 cs inner door felt strip and looks good.
 
eriknetherlands said:
Front turn signals actually have two seals; one between body and chrome base (which I think you already have pic of), but there also is a rubber gasket that seals the lens to the chrome base. In the attached pics (From ebay, it's for sale for a dump ass price of @ 600 usd...) you see the body rubber as a separate part, and the rubber between chrome and lens is still in place inside the chrome base.
Click to expand...
i am circling back to this post - i have looked and cannot find a part number or anything referencing the inner rubber under the lens for the turn signal. my car did not have them ... but that's not to say that they didn't turn to dust before i got the car. has anybody else seen these pieces? if they are supposed to be there, perhaps @alprada70 can make us some.
 
houseofdiesel said:
Question on rear quarter glass, what seals to the inside of the glass? Same seal as door but cut down? Or different number?
I found the door ones at Maximillian (max2002store.com) as e9 cs inner door felt strip and looks good.
Click to expand...
I sell the set for the front and rear windows
Screenshot 2025-10-03 at 11.39.15 AM.png
 
Last edited:
rsporsche said:
i am circling back to this post - i have looked and cannot find a part number or anything referencing the inner rubber under the lens for the turn signal. my car did not have them ... but that's not to say that they didn't turn to dust before i got the car. has anybody else seen these pieces? if they are supposed to be there, perhaps @alprada70 can make us some.
Click to expand...
Is this Scott's?
Screenshot 2025-10-03 at 11.41.26 AM.png
 
Alvaro, the one you make is the one that goes between the housing and the body ... and it fits GREAT! the question is about a gasket between the housing and the lens, which would be smaller and thinner ... but like i've said, never seen one before.
 
You must log in or register to reply here.
Back
Top