bump
Rubber FAQ
- Thread starter Markos
- Start date
@eriknetherlands ,
Turns out I do have those rubber washers for the blinker lenses. Here is a second set of measurements.
Turns out I do have those rubber washers for the blinker lenses. Here is a second set of measurements.
houseofdiesel
Active Member
Question on rear quarter glass, what seals to the inside of the glass? Same seal as door but cut down? Or different number?
I found the door ones at Maximillian (max2002store.com) as e9 cs inner door felt strip and looks good.
I found the door ones at Maximillian (max2002store.com) as e9 cs inner door felt strip and looks good.
i am circling back to this post - i have looked and cannot find a part number or anything referencing the inner rubber under the lens for the turn signal. my car did not have them ... but that's not to say that they didn't turn to dust before i got the car. has anybody else seen these pieces? if they are supposed to be there, perhaps @alprada70 can make us some.
already done:
oilsdesigngroup.com
more info: https://e9coupe.com/forum/threads/front-turn-signal-gaskets-csi-csl.36511/
6310 TURN LIGHT GASKET SET – OILS´s Design Group
oilsdesigngroup.com
more info: https://e9coupe.com/forum/threads/front-turn-signal-gaskets-csi-csl.36511/
Last edited:
I sell the set for the front and rear windows
Last edited:
Alvaro, the one you make is the one that goes between the housing and the body ... and it fits GREAT! the question is about a gasket between the housing and the lens, which would be smaller and thinner ... but like i've said, never seen one before.
Hans woonboot
Member
mwds
Member
Hmmm, without looking too deep into it, I wouldn't be surprised if it was this guy:
Haha, well played, @eriknetherlands . But I must point out that the realOEM drawing shows a return at the bottom so I'm not 100% sure. I (obviously) have not replace it on mine so I can't be fully confident
Vent rubber is only 10 1/2" long and has a different but similar shape with a return as Bo states..
is the vent rubber not an entire triangular piece?
shopware.bmw-oldtimerteile.de
edit: i see from Bmachine's pic you are talking about the outside rubber
Dichtung Ausstellfenster links BMW E9 2000 coupe NEU !
Dichtung für Ausstellfenster BMW Baureihen E9 2,5 -3,0 CSi CSL 2000 C CS CA Orig. Neuteile in topp Qualität !
shopware.bmw-oldtimerteile.de
edit: i see from Bmachine's pic you are talking about the outside rubber
mwds
Member
Thanks for the impressive reply rate; WOW. Yes to all. I believe it is that seal (oem 51216754323 / 4). I have found that the length is subjective in that many seals I am replacing are a little longer than required, so are trimmed to size. I found this with the leading edge seal to the rear quarter glass (what a joy that was to fit).
In this case vent rubber refers to the chrome window sill trim to the vent window assembly.is the vent rubber not an entire triangular piece?
Dichtung Ausstellfenster links BMW E9 2000 coupe NEU !
Dichtung für Ausstellfenster BMW Baureihen E9 2,5 -3,0 CSi CSL 2000 C CS CA Orig. Neuteile in topp Qualität !
edit: i see from Bmachine's pic you are talking about the outside rubber
@HB Chris / @rsporsche,
I will circle back to this eventually but do not have time to revise the initial FAQ post. It goes without saying, but you have my express permission to edit any post under my name at any time, for any purpose you see fit. In a perfect world where we are all swimming in time, the tables that I created are updated with screenshots, part numbers, etc.
I will circle back to this eventually but do not have time to revise the initial FAQ post. It goes without saying, but you have my express permission to edit any post under my name at any time, for any purpose you see fit. In a perfect world where we are all swimming in time, the tables that I created are updated with screenshots, part numbers, etc.